Angle-Pad Coupling 300Psi

Short Description:

an angle-pad design rigid coupling for moderate pressure piping services including fire mains, long straight runs and valve connections. The angle-pad design allows the coupling housings to slide along the bolt pads when tightened. The result is an offset clamping action which provides a rigid joint which resists so-called ‘snaking’ of a long straight run. Support and hanging requirements correspond to ANSI B31.1, B31.9 and NFPA 13.With the removal of only one bolt you can make a fast and easy ‘swing-over’ installation The angle pad design allows for fast and easy swing-over installation with the removal of a single bolt.

Send email to us

Product Detail

Product Tags

Style 1X Angle pad rigid Coupling

1.Product introduction:

The Angle-pad coupling design standard rigid coupling for the general piping application where rigidity is required including value connections,mechanical rooms,fire mains and long straight runs.The angle-pad design allows the coupling housings to slide along the bolt pads when tightened.The result is an offset clamping action which provides a rigid joint that resists flexural and torsional loads.Support and hanging requirements correspond to ANSI B31.1,B31/9 and NFPA 13.

•Model 1X Angle pad rigid coupling

•This rigid coupling allows for more accurate positioning of the tube end,forming a fixed tube end separation,which should be considered in the design and installation.

•Enhanced body resits 4 times working pressure.

2.Product size(Specification)

3.Product Feature And Application

Housing material:Ductile iron conforming to ASTM A-536,grade 65-45-12
•FM Approved & UL Listed:R.W.P.rated working pressure 300PSI(2.065 Mpa/20.65 bars)
•Housing Finish:Fusion Bonded Epoxy Coated(Optional:Hot Deep Galvanized and Others)
Coupling gasket material:EPDM(Optional：Nitrile NBR,Silicone and others)
•In addition to the points listed in this table,but also according to customer requirements to provide a variety of special point of the elbow.
•Size Range:DN25 through DN3000 (1’’ through 12’’)

4.Product Qualification